I broke down and cleaned my poor Victory today. I have been getting some feeding issues. That and it’s been about 600 rounds since the last cleaning. The feeding issues seem magazine related so I cleaned them too. Aguila SE standard velocity and S&B Target ammo seem to have more lube? It smears and slows the top round enough I’ll drop the hammer on an empty chamber.
It seems to get kinda dirty then just stay there. It didn’t look much different than a 100 round cleaning.
I’ll say I really like this pistol. It’s accurate beyond any other pistol I have, shooting just over an inch at 25 yards with match ammo. It is somewhat finicky and won’t cycle some standard velocity loads, but does fine with others. It runs near 100% with high velocity loads (1250 fps) and shoots Winchester M22 with alarming accuracy and reliability; 1 failure out of a 500 round box.
I mounted a Holosun red dot and it seems to work well. The rail came loose a couple of times then the sight came loose once so I can’t really say the rail is a polymer rail is a problem. It might be the nut behind the wrench when tightening both. My only complaint is it’s a bit heavy but that 1” stainless barrel has to count for something.
It seems to get kinda dirty then just stay there. It didn’t look much different than a 100 round cleaning.
I’ll say I really like this pistol. It’s accurate beyond any other pistol I have, shooting just over an inch at 25 yards with match ammo. It is somewhat finicky and won’t cycle some standard velocity loads, but does fine with others. It runs near 100% with high velocity loads (1250 fps) and shoots Winchester M22 with alarming accuracy and reliability; 1 failure out of a 500 round box.
I mounted a Holosun red dot and it seems to work well. The rail came loose a couple of times then the sight came loose once so I can’t really say the rail is a polymer rail is a problem. It might be the nut behind the wrench when tightening both. My only complaint is it’s a bit heavy but that 1” stainless barrel has to count for something.