I could, but if you go to the link I posted, then go to Page 1 of the thread, you can see pictures of his adapter (Prior to powder coating), then pictures of it on the rifle.. They're pretty accurate pictures. He's been producing these adapters for more than a year and a half. Those pictures are of the earlier batches, but the design is still the same. It's just that he will make about 100 of them, and then sell them. Months later, he will run out of them, and build another batch. It's not his full time job, so he doesn't run through thousands of these. But he is very reputable. I've never met him personally, but he was there for me step by step when I had lots of questions. The thread has about 17 pages, but just about everything anyone could think of asking him, is covered there. He's just on another batch now. He had to find a new machinist to build the most recent build, because the old machinist went out of business. But he has finished getting the individual parts built; he has put them all together; he's had them powdercoated; and he's tested them and they're ready for sale. Read the thread. I think all your answers will be covered. If not, just add an additional post on the end of the thread, and Renegadebuck will either respond there or PM you.