brewer12345
Member
- Joined
- Nov 29, 2015
- Messages
- 2,753
I tried out my new xdm with some factory ball and a couple ladders based on bullseye. With my home cast 200 grain swc the most accurate load.was with 6 grains. That is the top of the lyman 4 cast bullet manual range. I saw no obvious pressure signs, although with brass flying everywhere I could not really look at it to check the primers. Does this strike anyone as a foolhardy load to use? It is in a manual and not marked as +p, so likely safe, but I usually stay away from top end loads.