Kingcreek
Member
I would like to get the most accuracy out of my Tikka T3 Stainless with laminated stock and was wondering if there is any guidance on mounting screw tension in the stock. There is an aluminum bedding block inlet into the stock. I had to remove the floor plate/screws to set trigger weight down to 3#.
I know my mod 70 featherweight is real sensitive to screw tension but don't know about this Tikka.
any advice is much appreciated, thanks
I know my mod 70 featherweight is real sensitive to screw tension but don't know about this Tikka.
any advice is much appreciated, thanks