Saluki91
Member
I have been loading .45ACP 200gr LSWC with my Redding Pro die set, and have experienced no issues with the seating stem. However, when I attempted to run some 230gr LRN through the press, I found that the stem was really doing a number on the bullets... often leaving light rings, and occasionally cutting deeper. See the attached pic.
I cleaned and degreased the stem, but that didn’t help. This is the only stem in the box, and apparently the only one Redding offers for these dies.
Is there anything else I can do short of getting another seating die?
Thanks!
I cleaned and degreased the stem, but that didn’t help. This is the only stem in the box, and apparently the only one Redding offers for these dies.
Is there anything else I can do short of getting another seating die?
Thanks!