Setup/Context: 9mm; RCBS Carbide Dies; Single Stage Press
The other night I noticed I was getting a few rounds that weren't dropping into my case gauge all the way. I rechecked my sizing die and noticed that the bottom of the die wasn't quite to the shell holder. So I adjusted the die down until it touched the shell holder per RCBS instructions.
I still get an occasional case that won't quite go all the way into the gauge after sizing. What's the deal? Are there some cases that just won't size like they need to?
OR
The other night I noticed I was getting a few rounds that weren't dropping into my case gauge all the way. I rechecked my sizing die and noticed that the bottom of the die wasn't quite to the shell holder. So I adjusted the die down until it touched the shell holder per RCBS instructions.
I still get an occasional case that won't quite go all the way into the gauge after sizing. What's the deal? Are there some cases that just won't size like they need to?
OR