xlh883
Member
Hello folks, I just found that the firing pin on my new yugo sks is bent. last time it was stuck and full of crud but straight, I removed it and cleaned and it worked ok, yesterday I fired about 100 rounds to zero in my new scope.
today while I was cleaning it I noticed the pin was stuck. had some difficulty removing it. after and reassembly it wouldnt go in being bent about 3 degrees off true, had to use a vise to straighten it. but Im no sure if it will happen again. any suggestions? should I replace it with a non yugo type.This is the original triangular shaped firing pin. Any suggestions?
today while I was cleaning it I noticed the pin was stuck. had some difficulty removing it. after and reassembly it wouldnt go in being bent about 3 degrees off true, had to use a vise to straighten it. but Im no sure if it will happen again. any suggestions? should I replace it with a non yugo type.This is the original triangular shaped firing pin. Any suggestions?