I was resizing and de-priming some .38 caliber brass this weekend and must have missed one with the lube. Long story short, the case felt tight going up into the die, so I stopped and tried to remove the case to give it a spritz of lube when the case broke in half.:banghead:
The die set is RCBS and since the case split in the middle there isn't anything to get hold of to extract the case from the die now.
Any suggestions on how to remove the stuck case or do I just need to send it in to RCBS?
The die set is RCBS and since the case split in the middle there isn't anything to get hold of to extract the case from the die now.
Any suggestions on how to remove the stuck case or do I just need to send it in to RCBS?