Kingcreek
Member
I haven't had this happen in several years but now...
223 brass in full-length sizing die (Dillon. Carbide) with expander button stuck in neck and de-cap pin inside case of course. I can't seem to move the expander button down into the case and the end of the de-cap pin is flush with the flash hole so I can't drill and tap without damage to the pin. I used the tap and bolt trick years ago and I think I remember using a 1/4 bolt and spacers to draw it out.
How do I get this unstuck without damage?
Thanks
223 brass in full-length sizing die (Dillon. Carbide) with expander button stuck in neck and de-cap pin inside case of course. I can't seem to move the expander button down into the case and the end of the de-cap pin is flush with the flash hole so I can't drill and tap without damage to the pin. I used the tap and bolt trick years ago and I think I remember using a 1/4 bolt and spacers to draw it out.
How do I get this unstuck without damage?
Thanks