Stupid question of the week: I can't use a Gen 5 trigger housing in a Gen 3 Glock, right?
- Thread starter 1KPerDay
- Start date
- Status
OP
OP
1KPerDay
Member
I tried my Gen 3 G19 and the ejector does contact the rear of the top cartridge... but with the .40 mag it's much worse and obviously is problematic. I shot 3 more mags full with the 9mm mag and 9mm ejector and it worked okay but the last case dribbles out or goes to the left.
OP
OP
1KPerDay
Member
Okay but explain to me again why I want to use a .40 extractor when I know it was at least partially problematic/FTE and I'm not going to be shooting .40 through this gun?
LiveLife
Member
Was the .40 extractor ever used in conjunction with Gen4 .40 ejector?
If not, I would give that a try.
OP
OP
1KPerDay
Member
Okay:
New 9 mm ejector new 9mm extractor new 9mm mag mostly 3:30 ejection, no BTF so far, last case piddles out or goes left.
New 9mm ejector .40 extractor 9mm mag mostly 3:30 one case to the head out of 11 rounds.
New .40 ejector 9mm extractor results in above thread
New .40 ejector .40 extractor 5:30 ejection or over shoulder/head. With 9mm mag 2 BTF 5 to shoulder/arm, similar results with .40 mag plus one FTF with .40 mag.
New 9 mm ejector new 9mm extractor new 9mm mag mostly 3:30 ejection, no BTF so far, last case piddles out or goes left.
New 9mm ejector .40 extractor 9mm mag mostly 3:30 one case to the head out of 11 rounds.
New .40 ejector 9mm extractor results in above thread
New .40 ejector .40 extractor 5:30 ejection or over shoulder/head. With 9mm mag 2 BTF 5 to shoulder/arm, similar results with .40 mag plus one FTF with .40 mag.
LiveLife
Member
Good to see you making progress! 
OP
OP
1KPerDay
Member
Not sure I’ve made any. I’m getting really good at detail stripping Glocks though 
JRadice45
Member
Unless you feel like buying a proper 9mm breechface slide this will be your best combo.
Like you said, at least you didnt get beaned
OP
OP
1KPerDay
Member
Yeah that’s what I figgered also.
- Status
