Just swapped the XR3 frame on my new to me 30 Carbine black hawk for a stainless SBH Dragoon frame and wanted to show it off.
This was a used frame i got cheap off gunbroker, so it was already fit to a different gun. As it is all the holes lined up, but the edges of the frame are a little proud on the right side.
The grips are off my buddies SBH Hunter, but ive got a set of black swirly things with red ruger medallion on the way....it'll match my Wrangler in that aspect.
Only work i did on the frame was media blasting it to gray, since i much prefer that to polished stainless. I may file the right side to match and re-blast eventually, but im not sure i care that much about the slight mismatch.
I much prefer the extra length of the SBH frame. I cant stand tucking my pinky under, even on the wrangler, which i may swap to an sbh frame also if i can.
This was a used frame i got cheap off gunbroker, so it was already fit to a different gun. As it is all the holes lined up, but the edges of the frame are a little proud on the right side.
The grips are off my buddies SBH Hunter, but ive got a set of black swirly things with red ruger medallion on the way....it'll match my Wrangler in that aspect.
Only work i did on the frame was media blasting it to gray, since i much prefer that to polished stainless. I may file the right side to match and re-blast eventually, but im not sure i care that much about the slight mismatch.
I much prefer the extra length of the SBH frame. I cant stand tucking my pinky under, even on the wrangler, which i may swap to an sbh frame also if i can.