Turn the die in 1/4 (.017") turn after contact with the shell holder? And still, no ones measures to determines if the die made down to the shell holder when the ram is raised. Then there is turning the die down an additional 1/4 turn or .035” and still no contact between the shell holder and die.
I went to help a friend, I raised the ram, I adjusted the die to the shell holder, no luck, I lowered the die two full turns, the gap between the bottom of the die and top of the shell holder was .017” on an AMMO MASTER press.
I made a comparator to measure new, unfired factor arsenal made ammo with his fired and sized cases, he did not like the results. He would not consider the case had more resistance to sizing than his press could overcome.
He had no interest in improving on the Imperial sizing wax or the Dillon in the can or bottle.
F. Guffey
I went to help a friend, I raised the ram, I adjusted the die to the shell holder, no luck, I lowered the die two full turns, the gap between the bottom of the die and top of the shell holder was .017” on an AMMO MASTER press.
I made a comparator to measure new, unfired factor arsenal made ammo with his fired and sized cases, he did not like the results. He would not consider the case had more resistance to sizing than his press could overcome.
He had no interest in improving on the Imperial sizing wax or the Dillon in the can or bottle.
F. Guffey