Taurus Model 85ch reassembly.

[lizzyp93]

Good day all,
A dear friend of mine decided to do a hammer and trigger spring job on the afore mentioned little revolver, and as he has been unable to fully reassemble it I have been called into service.
Everthing has been reassembled except for the transfer bar and the hand and I just cant seem to figure out how the 2 little pieces fit together.

Now.........If anyone would be so kind to post a picture of a taurus small frame .38 with the grip and side cover removed so I could have a look I would be most happy.

Thanks much........................

 

[Jim K]

I don't have a picture, but IIRC, you have to assemble the transfer bar, hand, hand spring and hand spring plunger in the trigger before installing the trigger. The cylinder stop should be in place first. Then install the trigger, followed by the trigger return spring and plunger. Finally, the hammer goes in, followed by its spring and plunger.

Jim

 

[lizzyp93]

Ok Guys & Gals,
I'm still not "Getting it". No pictures anyone?

 

[Jim K]

Again IIRC, the transfer bar and the hand don't "fit together". They go on opposite sides of the trigger.


Jim