The Official Holster cross-compatibilty thread.

[lgcal20ga]

I didn't check the whole thread, so I hope I'm not duplicating something previously posted, but I just started using my Fist IWB holster made for the CZ-83 with my Llama IIIA. Works great, when its inside the pants, just a wee bit loose otherwise. Not too much of a problem though, I'm happy with it. Can't find a holster for the IIIA anyhow, so I guess it will have to do.

Larry

 

[wade11a]

bersa thunder holster?

Will a bersa thunder .380 fit in a Don Hume JIT slide holster for a makarov 9mm?

 

[167xray]

Hi all, this is my first post. im looking for something that will fit my s/w model 13 6inch, like a fobus type of holster. i would like it in a cross draw setup as a backup to my glock 22. (i work an armored car detail) i also have a model 60 i ground down the hammer on it , and the holsters i have seen all seem to use the hammer with the thmb break strap to secure the weapon. any ideas? any one last thig, i have a cz83, and again, i really like the fobus type holsters but i also want to get a mag pouch single or dual for it. any suggestions? this is a great thread and hasbeen really helpful with some of my other weapons! Thanks in advance!

 

[DAdams]

Pocket Holster

DeSantis Nemesis pocket holster for a S&W J Frame works nicely with a Kahr PM9 or equivalent.

 

[BADUNAME37]

My Desantis Gunhide Ankle Holster, with garter, works for both my LCP .380 and my 642 .38 Special! The .38 is a tad tight, but it definitely will not come out by accident and the entire trigger guard is covered!

The snap straps that hold the gun in the holster are completely adjustible as they are all secured with velcro.

 

[slipstrm]

At the risk of reviving and old one....Walther P99 galco fletch will also fit Sig P226.

 

[JTQ]

Most handguns cost somewhere from $500 to $1,000 plus. If you can afford a new gun, spend the extra $100 and get a holster that fits your gun.

 

[Boothg599]

Bersa Thunder 9 Pro HC / XT

Anyone know a good holster for a Bersa Thunder 9 Pro HC / XT. I know the Fobus paddle holster for the sig p239 works but was looking for something that has a retention clip or something similar. For example, does anyone know if the SigTac Roto Retention Paddle Holster for SIG P239 works with these guns? No soft holsters please. Thanks in advance for any help!

 

[JTQ]

Bersa Thunder 9 Pro HC / XT

I'm not familiar with the Bersa line-up, which one? https://bersa.eagleimportsinc.com/bersa/firearms/thunder-pro-series

...looking for something that has a retention clip or something similar. For example, does anyone know if the SigTac Roto Retention Paddle Holster for SIG P239 works with these guns? No soft holsters please. Thanks in advance for any help!

What is the planned use for the holster? Does that mean you want a kydex holster and leather is not to be considered? Do you need a paddle? Does it have to have active retention or just something more than gravity?

 

[Boothg599]

This is the gun I have

Yes, Kydex is preferred. It will be for open carrying. Active retention if possible. I want the extra step for anyone trying to grab it. Paddle is more of a nice to have.


I have found that XD9 kydex holsters sometimes fit it so I am gonna try this one.

I will let you know if it works. But please continue to post any suggestions. Thanks!