Here's one I ran 4 years ago:
First run of the day was with the S&W 442 using Federal 158 grain LSWCHP+P. Target was a sheet of copy paper at 5 yds. At signal, I thrust towards the target and fired 5 shots. They were:
.67
.28
.25
.25
.24
-------
1.69 total time.
Group size was 3 3/8th's", with the best 3 right at one inch.
Comment: I thought this was a pretty good cold run with a gun I've not shot for a couple years. I also felt like I went slow, to ensure good hits.
I can't get the picture to display, sorry. If anyone cares, the thread was called "Range trip with SD drill results" in the "General Handguns" area.
So you shot that from a high compressed ready?
Just wondering.
Sounds very similar to Claude's 5^5 drill.
Cold: 5 shots at 5 yards into a 5 inch circle in 5 seconds or less. Repeat 5 times as a basic standard for CCW proficiency.
I ran it over Christmas with my 38 special lcr and scored 24/25. No misses but one shot was over par.
In my defense I ran it wearing a brand new winter jacket from a belly band, and I was sick... Yeah I know, excuses . I also didn't live fire for at least 2 months previously. I'd always like to be better (and have definitely turned in way better performances in ideal conditions) but all things considered these were imperfect but typical conditions, and I wasn't terribly displeased - if that's the worst it gets it can only get better under better conditions.
Most of my draw times were 2 seconds or a bit over. Splits were mostly just under 0.5 (strings totaled mostly just under 4.5 except the one over par due to a slowwwww 2.5 sec draw).
Not to put words in his mouth but Claude has hinted that this would be a good litmus test for basic ccw proficiency. I felt bad for not getting a perfect score but then I remembered the basic standard was from low ready or high compressed ready and felt a bit better!
Last edited: