Thin grips for Beretta 92F

[mtnbkr]

Who makes the thinnest non rubber/plastic grips for the 92F? I have the factory wood grips, but I'd like something a bit thinner. I don't mind alternative materials (micarta, G10, Aluminum, etc), but I do not want plastic or rubber. Frankly, I want something that'll dress this gun up a bit or make it unique.

Chris

 

[BerettaNut92]

The carbon fiber grips are thinner but to the point where if you're not careful the grip screws may run into the mag and make them hang up. I back them off a little then loc-tite them.

I think the rubber panels (Hogue?) are thicker than plastic, at least they feel that way.

Haven't played with the wood ones but some of them sure are purty!

 

[mtnbkr]

Where would I find these grips?

BTW, why not trim the length of the screw down a bit? If it's just a hair long, you can use the side of a dremel cuttoff wheel as an angle grinder to remove a mm or so (careful of your fingers...).

Chris

 

[BerettaNut92]

I'm not telling!

Just kidding, it's www.carboncreations.com

 

[mtnbkr]

Hmmm, me likeum Smooth Polished Ultra Thin in Red.

Chris

 

[BerettaNut92]

Then you can get these gloves to match: