Hello all. I was hoping to get some thoughts and advice on a small issue I have on my model 27-2. Some time ago I pulled it apart and replaced some worn parts (spring kit, over-sized arm, over-sized cylinder stop) to tighten it back up after a hard life of use before I got it.
I also did a polish job on all the internal wear surfaces. I was very happy with the smoothness of the action and the crisp break of the single action trigger, although it was very light.
Now after about a 1000 rounds or so, about half full power, the single action trigger break is light enough that I am a little uncomfortable with it. It will also not stay locked if you push hard on the hammer anymore.
Is there a way to reshape the hammer or trigger seer, or should I just replace one or the other? Thanks in advance for any advice!
I also did a polish job on all the internal wear surfaces. I was very happy with the smoothness of the action and the crisp break of the single action trigger, although it was very light.
Now after about a 1000 rounds or so, about half full power, the single action trigger break is light enough that I am a little uncomfortable with it. It will also not stay locked if you push hard on the hammer anymore.
Is there a way to reshape the hammer or trigger seer, or should I just replace one or the other? Thanks in advance for any advice!