Clark
Member
I have never made a knife before.
My son was throwing a $9 pair of broken scissors in the garbage this morning.
I watched some knife making videos on youtube. They used pins and epoxy.
I drilled holes in the scissors with a carbide end mill I got from Boeing surplus 10 years ago.
i used a sink drain rod for the brass pins.
I used scrap ironwood from someone's decking project.
I used Devcon liquid steel that is too runny for my gunsmithing.
The guys in the videos used 5 minute epoxy. I am going to have to wait overnight. That was fun.
My son was throwing a $9 pair of broken scissors in the garbage this morning.
I watched some knife making videos on youtube. They used pins and epoxy.
I drilled holes in the scissors with a carbide end mill I got from Boeing surplus 10 years ago.
i used a sink drain rod for the brass pins.
I used scrap ironwood from someone's decking project.
I used Devcon liquid steel that is too runny for my gunsmithing.
The guys in the videos used 5 minute epoxy. I am going to have to wait overnight. That was fun.