I have a pristine early model SX-1. I'm sure it has the original first generation trigger assembly. This trigger has an allen screw trigger adjustment. I also believe it has the older dual spring set up. Anyway, I have tried to adjust the trigger for some pre-travel but not a lot. The problem is the adjustment wont stay at such. The trigger migrates back to the no pre-travel position to the very rear of the trigger guard. It works but I would like more feel in the trigger pull. Any thoughts?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Trigger problem with Win. SX-1.
- Thread starter mach1.3
- Start date
- Status
-
Not open for further replies.
Oh, btw, this shotgun has only one very light solitary scratch on the left side of the receiver--but other than that it is perfect. It is not the more valued Trap-model with the engraved receiver. I have replaced the recoil pad so that's not original. The VR is a Simmons Trap with a red-fluorescent tube sight done by the renown Simmons Specialties in KC, Mo. I had initially used it for trap but now only occasionally in the field. This gun is heavy but shoots straight(slightly above LOS) a la a trap gun. It used to be my Dad's and he almost never used it since he was a devout Browning A5 and Broadway OU man. If I can figure out how to post some pictures here I will.
- Status
-
Not open for further replies.