Greetings,
When I trim my brass with my "orange" lathe (Lyman), the pilot pin most of the time will not penetrate into the mouth of my 223 brass. It is too tight. I tried to lube it and it still is too tight.
I know using the pilot ensures the case is trimmed straight.
I use the Dillon decapping/sizing die. Is there something I do wrong?
I was tinking to remove just a little bit of material off the pilot pin...
Thank you
When I trim my brass with my "orange" lathe (Lyman), the pilot pin most of the time will not penetrate into the mouth of my 223 brass. It is too tight. I tried to lube it and it still is too tight.
I know using the pilot ensures the case is trimmed straight.
I use the Dillon decapping/sizing die. Is there something I do wrong?
I was tinking to remove just a little bit of material off the pilot pin...
Thank you