wichitadude
Member
- Joined
- Dec 28, 2020
- Messages
- 2
I have run into a problem that I am unable to solve.
When using the RCBS carbide 45 colt sizing die, I am getting a bulge at the base of the 454 case. This bulge is about .010 larger than the case mouth diameter. Base measurers .0478, mouth .0468.These cases will not go completely into a case gage
When using the RCBS carbide 45 colt sizing die, I am getting a bulge at the base of the 454 case. This bulge is about .010 larger than the case mouth diameter. Base measurers .0478, mouth .0468.These cases will not go completely into a case gage
Last edited: