kmw1954
Member
So here it is set up in the New Auto Beech Lock Pro press with Xtreme 115gr RN bullets loaded in the tube. I'm using it in the 3rd position along with everyday normal Lee Carbide 3-die set and seating/crimping in the last die.
The whole purpose of doing this wasn't to speed up the process but to just make it easier not having to reach around to the rear of the press to place the bullet in the case. It has done that wonderfully! So far as a test I've run one tube which hols 30 of these bullets and had 2 that did not drop and I think that was because one got hung up in the tube and there was a gap, reducing the weight load. Then as I got to the end with only 5 left it stopped feeding again.
As some may remember I also tried doing this with the Hornady Bullet Feed die and had no luck at all. So I am quite happy with this outcome.
I have some 124gr Berry's FP bullets sitting on the shelf and now I'm going to have to go see how well they feed and if I still get a stuck one in the tube or if the flat point helps prevent that.