silicosys4
Member
- Joined
- Jun 29, 2012
- Messages
- 3,691
I ordered 300 270gr. RN .375 blemished bullets from midway last week
I have had good luck with blemished bullets before, but this time the blemishes are physical rather than cosmetic.
Looks like the cannalure is out of spec for many of the bullets.
They all measure .375 at the bearing surface,
But at the cannalure they measure from .370 all the way down to .353!
Now that's a deep cannalure.
It's all going to go through a ruger no. 1 single shot in .375 h&h
Should I just set the crimp as normal?
I have had good luck with blemished bullets before, but this time the blemishes are physical rather than cosmetic.
Looks like the cannalure is out of spec for many of the bullets.
They all measure .375 at the bearing surface,
But at the cannalure they measure from .370 all the way down to .353!
Now that's a deep cannalure.
It's all going to go through a ruger no. 1 single shot in .375 h&h
Should I just set the crimp as normal?