I have been shooting a load in my 45acp that is 200gr SWC with 5.0 grains of 231. It seems kind of dirty. After about 100 rounds it feels slightly gummy. Is there a powder that is slow like that with similar metering ability and cleaner burning.
W-231 ??
- Thread starter 72IH
- Start date
- Status
Chief-7700
Member
You could try Titegroup.
Chief
Chief
rcmodel
Member in memoriam
You sure it's the powder that's dirty?
Could be the bullet lube from the 200gr SWC?
rc
Could be the bullet lube from the 200gr SWC?
rc
The Bushmaster
Member
It's not the powder (W-231). It's the lube. W-231 is a rather clean burning powder at low or high powder charges. It is a fast burning powder and burns rather hot. That, in itself, could be the problem. Can you reduce the amount of lube you are using? Other then the messy grease...Aah...Lube you are using. Any other problems with W-231?
I bet you guys are right. Its prolly the lube. Never had an issue with 44 special. These are the first 45acp that I loaded. New bullet brand I am trying. I had used Lasercast in the past and didn't notice anything, but only in 44. I don't know what kind of lube these have other than it's blue. Bullets are from a local guy here casting his own and way cheaper than lasercast.
rfwobbly
Member
Win 231 has always run very clean for me. I think RC and BM are onto something.
ArchAngelCD
Member.
When in doubt if the powder is dirty or not load up some FMJ bullets and you will quickly find out if it's the powder or the lube on the lead bullets. I like the others have never had W231 run dirty in my reloads. I have had some very dirty lube on lead bullets though. (the red stuff is worse than the pine green or blue lube)
- Status
