Schwing
Member
I have seen all kinds of advice about how long to wait or even if it is necessary to wait after casting bullets before you size and load them. I am curious what folks here at THR have found works for them.
Ive had neither good reliability nor accuracy without sizing (with the exception of revolver projectiles) so I wish I was among those of you who don't size at all
I have recently started powder coating my bullets so I cast and powder coat immediately after since you have to heat them back up again to do that. What I am curious about is if it really matters if you wait a few days to size them or if I should just go for it and forget the wait. Do any of you notice shrinking etc if you don''t wait?
Ive had neither good reliability nor accuracy without sizing (with the exception of revolver projectiles) so I wish I was among those of you who don't size at all
I have recently started powder coating my bullets so I cast and powder coat immediately after since you have to heat them back up again to do that. What I am curious about is if it really matters if you wait a few days to size them or if I should just go for it and forget the wait. Do any of you notice shrinking etc if you don''t wait?