Hello, I just put an ultimak mount and an aimpoint compc3 on my SOCOM 16. I'm about 80% sure that I was sent an aimpoint weaver ring. The gaps between the rails are .3 inches and the crossbar of the ring is .22 inches.
I read that the gap should be 5mm for Picatinny and 3.8mm for Weaver, but I don't have any metric measuring tools.
I tightened up the ring so it is very solid side to side, but if I go and fire my M1A, will the recoil shift the ring and sight slightly to the rear?
By the way, the set-up looks fantastic. The aimpoint is neat and I can see the iron sights perfectly through the scope.
I read that the gap should be 5mm for Picatinny and 3.8mm for Weaver, but I don't have any metric measuring tools.
I tightened up the ring so it is very solid side to side, but if I go and fire my M1A, will the recoil shift the ring and sight slightly to the rear?
By the way, the set-up looks fantastic. The aimpoint is neat and I can see the iron sights perfectly through the scope.