I got my new Fusion match barrel bushing in today. When I got it home and measured it, it is the same dimentions as the factory one, therefore not tightening up the way I wanted. No need for a wrench on this one either. I can turn it with my little finger.
When the slide is all the forward (As in the position to fire", The bushing to barrel is tight, when the slide is locked back however, I can put my little finger in the end of the bore and wiggle it. It has some play and is a little loose. So , how do you decide if its tight enough or not, In the ready postion or with the slide locked back? Thank you
Whiteymin
When the slide is all the forward (As in the position to fire", The bushing to barrel is tight, when the slide is locked back however, I can put my little finger in the end of the bore and wiggle it. It has some play and is a little loose. So , how do you decide if its tight enough or not, In the ready postion or with the slide locked back? Thank you
Whiteymin