I bought my first reloading press not long ago, a Redding Big Boss II. A family member was using my garage and tools (without asking) while I was out and put a fine layer of MDF plywood dust on my press. I blew all of the visible dust out, but I didn't disassemble it or anything so it's not been 100% cleaned out.
Assuming it is salvageable, how should I go about cleaning it? Once I've got it cleaned, I'll be putting a cover on it as well as throttling my cousin so he doesn't accidentally use my shop again.
I've been doing some hardcore Google-ing to see what I can find out, but have not found that much about cleaning the Big Boss II. (Side note: can someone at Redding spring for a website designer? 50$ out of the press I just bought would take them further than they currently are )
Love this forum by the way. It's a wonderful resource.
Thanks!
Assuming it is salvageable, how should I go about cleaning it? Once I've got it cleaned, I'll be putting a cover on it as well as throttling my cousin so he doesn't accidentally use my shop again.
I've been doing some hardcore Google-ing to see what I can find out, but have not found that much about cleaning the Big Boss II. (Side note: can someone at Redding spring for a website designer? 50$ out of the press I just bought would take them further than they currently are )
Love this forum by the way. It's a wonderful resource.
Thanks!