Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WTK: Height of XL650 w/ strong mount and case feeder?

Discussion in 'Handloading and Reloading' started by mpthole, Aug 17, 2003.

Thread Status:
Not open for further replies.
  1. mpthole

    mpthole Member

    Joined:
    Dec 24, 2002
    Messages:
    1,058
    Location:
    Wisconsin
    Well, I'm getting all settled into my new house and before I set up my press again I've got to decide the best place to put it and whether or not I need to build a new bench or use an existing one. To do that I need to know the height of the XL650 with the case feeder using a strong mount. Can someone out there measure their's for me before I unpack mine?

    TIA! :)
     
  2. Jeeper

    Jeeper Member

    Joined:
    Dec 28, 2002
    Messages:
    1,062
    Location:
    Mesa, AZ
    Mine is right about 45 inches tall. My bench is 42
     
  3. mpthole

    mpthole Member

    Joined:
    Dec 24, 2002
    Messages:
    1,058
    Location:
    Wisconsin
    Thanks Jeeper! :)
     
Thread Status:
Not open for further replies.

Share This Page