Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Your Recommendations: Rigs for CCW S&W 4" M66...

Discussion in 'Handguns: Revolvers' started by CaptSkip, Nov 9, 2004.

Thread Status:
Not open for further replies.
  1. CaptSkip

    CaptSkip Member

    Joined:
    Feb 13, 2003
    Messages:
    24
    Location:
    Oklahoma
    ...waist cross-draw from left with right-hand;

    Left side shoulder rig;

    Small of the back waist;

    Open to any sugestions for comfort and accessability.

    Thanks!
     
  2. pcf

    pcf Member

    Joined:
    May 5, 2003
    Messages:
    862
    Location:
    Arlington, TX
    For Starters a good double thickness belt Kramer, Milt Sparks, Tucker.........

    Tucker Gun Leather
    www.tuckergunleather.com
    Texas Heritage is a tuckable IWB. You will need bigger pants to use this, +2" in the waist.

    Kramer Leather
    www.kramerleather.com
    Horsehide holsters, don't have for revolvers last one for a 1911 was too tight and had to send it back to get refit. Great belts though.

    Edited Filson also makes a double thickness belt that works great and since it's not marketed as a "gun belt" it retails for about $30 less
     
  3. Bulldozer

    Bulldozer Member

    Joined:
    Dec 27, 2002
    Messages:
    338
    Location:
    Kansas City Metro
    Crossdraw choice is easy...

    Mitch Rosen's Tito's Revenge.

    Good shoulder rigs can be had from Andrews, Buhlman, Del Fatti, and Alessi.

    Best IWB for revolvers are Versa-Max II and Texas Heritage. Alessi makes a nice belt slide holster for OWB.

    Just my unvarnished opinion.
     
  4. CaptSkip

    CaptSkip Member

    Joined:
    Feb 13, 2003
    Messages:
    24
    Location:
    Oklahoma
    Thanks for all the suggestions. :)

    Lots more to choose from than in the days of Bianchi and Safariland!

    The Rosen, Sparks, & Tucker lines look extra good.
     
Thread Status:
Not open for further replies.

Share This Page