The RCII is a smaller press (slightly) I can run 300 win mag through my RC all day long, but the clearance my RCII is just barely too small to accommodate when seating bullets.
I used evaporust to strip the remaining bluing off an old 38. It worked far better than I would have imagined. I actually was just trying to take the rust off the frame and side plate and after a 24 hour soak the rust and all bluing was gone. They I had the whole thing ceracoated. I couldn't be...
45 is pretty low pressure, for 45 I use it all with the exception of steel and American. Remington is good to go:)
I stopped using the remington .223 a few years ago because I found the bases to be a bit soft and I ended up with a ton of LC.
Cheers
I first noticed this bullet company a few months ago on Midway I found the companies website today:
http://www.generalbullet.com/
Has anyone used their components?
How do they compare to Barnes?
Thanks!
Oddly enough I was at BassPro (288 and Beltway) They had a good powder selection including 2400 and a decent variety of bullets. They didn't have much in the way of primers, brass, or actual reloading equipment.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.