Remington 1100 Action Spring Tube

[Birddog13]

I am wondering if anyone could help explain how someone could change the Action Spring Tube on a Rem 1100. I have the replacement from Remington, but can not figure out how it comes off. Is it a job for a gunsmith?

Gun was a victom of a break-in. Guy tried to "saw off" the butt stock and when he got down to the action spring tube he could not saw anymore. I bouth the gun cheap and I'm trying to replace.

Thanks for you help.

 

[JohnBT]

From www.ahlmans.com

REMINGTON 1100/ 1187 WORK
Re-solder original magazine tube $80.00
Fit/Solder new Mag. tube $110.00(tube extra)
Solder in new Int. Latch Stud $40.00
Remove damaged int. latch stud $25.00
Solder new barrel guide stud $60.00(stud extra)

Solder action spring tube $50.00 <=<=<=<=<=

Re-solder loose barrel support $35.00
Fit/ Solder new barrel support $45.00(support extra)

 

[9mmMike]

Guy tried to "saw off" the butt stock and when he got down to the action spring tube he could not saw anymore. I bouth the gun cheap and I'm trying to replace.

Sure. It's always someone else....... Just kidding. Good luck with that repair. I hope the gun was real cheap.

Mike

 

[Birddog13]

Thanks

Thanks that helps. I was not forsure if it was soldered or dry fit.

Thanks again