Stripper guide for the Stevens 200 pseudo-Scout I'm building.

[JesseL]

Now I need to get some stripper clips and see if it works

If it works, I'll duplicate it in steel. I'm not sure how much I can trust those little aluminum nubs, but cutting aluminum is so much less hassle for a prototype.

 

[35 Whelen]

Good job! Does the rear ring extend far enough forward so if a guide were milled into it, it would work?

35W

 

[dprice3844444]

m-14 mags?

 

[JesseL]

Thanks! I don't think it could be milled into the rear ring and still line up with the back edge of the magazine. I could move the magazine back a smidge, but I think it might start running into the rear action pillar.

 

[JesseL]

m-14 mags?

Yep, but fixed and non-removable in this case. That's why I wanted to have the ability to use strippers.