William Young
Member
- Joined
- Jun 10, 2018
- Messages
- 33
In the pictures I see your die is not correctly setup.
Like in the instructions I linked to, screw the die into the press until you touch the shell holder. Then add an additional 1/2 turn down. This is why the shell holder didn't matter. Please just do that before anything else. I can see the bullet is very deep into the die and there is no way it can crimp the brass.
Screw the die in until you touch the shell holder and then add an additional 1/2 turn!
How is it not set up correctly... it's fully closed at full up stroke. I turned it down until it touched and then a WHOLE turn to fully close the collet.