Another problem of course.
New stock for M1 Garand. All went well until I went to do the last step & close the
trigger group. It slips into the bottom easily but when I try to close the trigger downward,
it starts but the plate presses hard against the stock opening, I fear pressing harder will
bend the assembly.
In the pic: The red arrows show the overall hard downward contact & the blue arrow shows
how far the trigger can move, which isn't far.
Question is = Does this call for removing wood from under the base plate in small amounts
until it snaps in place properly or did I guess wrong?
Just finished looking all over You Tube for an answer so I wouldn't have to bother you guys
AGAIN with another problem. I know I do it to much.
New stock for M1 Garand. All went well until I went to do the last step & close the
trigger group. It slips into the bottom easily but when I try to close the trigger downward,
it starts but the plate presses hard against the stock opening, I fear pressing harder will
bend the assembly.
In the pic: The red arrows show the overall hard downward contact & the blue arrow shows
how far the trigger can move, which isn't far.
Question is = Does this call for removing wood from under the base plate in small amounts
until it snaps in place properly or did I guess wrong?
Just finished looking all over You Tube for an answer so I wouldn't have to bother you guys
AGAIN with another problem. I know I do it to much.