gnappi
Member
A few months ago I started powder coating several thousand bullets I cast years ago. I had many .40 and 9mm bullets cast but since TMJ and FMJ's were so cheap I use them instead of my own cast.
Since bullets became unobtanium and I REALLY disliked the smoke and lrading my bullets caused, powder coating was a way to get a lot of essentially free bullets and save a lot of buckazoids.
With the PC'd bullets I'm using FMJ load data in my 9's and .40's and soon will start loading .45's to balance my primer usage.
If anyone has not tried it and you're setup for casting, give it a go, initial expense and setup is minimal.
Since bullets became unobtanium and I REALLY disliked the smoke and lrading my bullets caused, powder coating was a way to get a lot of essentially free bullets and save a lot of buckazoids.
With the PC'd bullets I'm using FMJ load data in my 9's and .40's and soon will start loading .45's to balance my primer usage.
If anyone has not tried it and you're setup for casting, give it a go, initial expense and setup is minimal.