Anyone have experience with this mold? I just did a bonehead move. Got through loading up about 100 rounds before I realized I had not plunked tested. Plated, jacketed 230g fmj's I usually run @ 1.165", went to plunk my cast loads, which were at 1.165...no dice. Ok, fair enough, my bad. Figured I'd need to seat them a little deeper. Yeah, .105" deeper. Had to go to 1.060" to keep them from hitting the lands in a standard GI Colt 1911 barrel. The case mouth is beyond the ogive at that seating depth. Is this mold only meant to be used with 45 Colt loads? 10, 20 thousands deeper to accommodate a rounder bullet profile, that I get. 100 thousands...not so much. Not sure if I should be disappointed with Lee for making a mold that makes a bullet that doesn't fit the intended cartridge, or myself for not realizing its meant for a different cartridge.