I’m not sure that you can adjust that rear sight other than maybe with a hammer for windage. Mine shoots pretty much to point of aim without any adjustment so I’ve never looked. There may be a locking screw that can be loosened to move.
I unscrewed the Allen in front of the sites however that's the firing pin. I put it in a vise and applied pressure, finally got it to drift. I only needed a bit, was shooting low and left, low I'm fine with. Thank you. How does yours shoot?
I have an older one so I'm not sure if anything has changed. On mine you can drift the rear sight. If it's shooting too high or low you can get a set of different height front and rear sights for very cheap on Amazon.
As a side note I wouldn't change the sights until you've put a few hundred rounds through it. The long/heavy trigger takes getting used to and will likely change your point of aim until you've practiced with it a bit.
Most right handed shooters will push the gun low left until you and the trigger become one. I would not adjust sights until you are REAL familiar with it.
Jeff
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.