All of the tube mag extension by Xrail have an O.D of 1.125 yet nobody makes a barrel clamp that I can find. Does anybody know of a barrel clamp that will fit a tube that large ? The Nordic is made for a 1.06 tube and Xrail does not make one,
Thanks,Keith
I shoot some local 3 gun matches and have trouble hearing the hits on steel. I can't hear out of my right ear at all and the range officers stand on the right and call shots or I think they do can't hear them to well. Would a 300 Blackout help by hitting the steel harder and making it easier to...
It loads with moon clips so head space is not an issue. Can I cut a cannelure in the bullet they roll crimp for a smooth reload ? Has anybody tried it yet ? I know I can chamfer the charge holes,
Thanks,Keith
I need a bullet that makes a big splash or dust cloud or gives me some indicator the steel was hit ? I only have one ear that works so I can't hear the hits. It is during a 3 gun match so others are shooting at the same time on other stages. The steel plates are big and heavy so they don't move...
Do 3 gun shooters run a 23 inch barrel for the 10 shot extenion or is it to get the gas system to run low brass rounds ?
Does the length of the barrel have any impact on the gas system like it does on a AR ?
Thanks,Keith
Will a barrel for a Benelli Supernova fit a Benelli Supernova Tactical ?
Will an old Remington 870 Wingmaster work with a new 18.5 inch barrel for the 870 Express ?
Thanks,Keith
Can you use a Carbine lower with a rifle in the 308 both AR-10. In other words is it OK to mix and match the uppers and lowers with the AR 15 and AR 10's ? 5.56 with the AR15 and 308 with the AR-10
The buffers are longer in both guns in the rifle. In the AR15 there is a weight difference...
I have a 40 and a 9mm XDm the XDm 40 has a red dot on it. Can I just take the 9mm and put it on the 40 lower and shoot it safely ? I know I will have to adjust the dot,
Thanks,Keith
With 15 inch pounds on the ring screws my scope will turrn it is no where near tight. I tried tacking some off of the little tit that keeps the rings from sliding forward or backard still it moves. anybody know a fit for it,
Thanks,Keith
Meopta 1-4 new reticle ?
I seen a clip on you tube about a new reticle for the 1-4 scope. The K-Dot works but has anybody seen the New reticle due to be out in March ?
Thanks,Keith
Burris 1x FastFire II Red-Dot Reflex Sight is it visible at night ?
Trijicon Red Dot Sight is it visible at night ?
Looking for something to piggy back on top of a scope like they do on the ACOG. For the real close up shots,
Thanks,Keith
Are there any know problems with the Aimpoint like the battery contact problems with the EOtech ? I can see how the Eotech would have a problem the AA battery is in a position to shift under recoil and over time cause a problem. I can see how the Aimpoint would not have the problem. The new...
Should it be shot like a 1911 or should it be shot like a D/A auto ? I know some say shoot a DA/SA just like a 1911 others say shoot it like a revolver. Yet others say shoot the DA/SA with the first joint and keep the finger there for all shots. Use the tip of the finger or the first joint of...
The grips control recoil like no other but now the sear pin on the Para LDA 7 walks out because they do not cover the pin like the factory grips did. How can I stop the pin from walking out under recoil ? Will I damage the frame if I knock a flat spot on the pin then drive it in place ? Would...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.