Search results for query: *

Gents/Ladies, Does anyone have suggestions on curing the carrier from sticking up and thus dropping the shell from the magazine on ground ? (12 ga) Thanks,

Looking for a Rossi Squire 20 ga foreend iron. Wood does not matter. Thanks, Oneeyejd

When shooting the UPPER barrel, the action "Jams" and is difficult to open. Lever lock is fine, smooth; the fired shell shows "some" small firing pin drag marks in primer. Have polished firing pins, etc and they are smooth and free. Action does NOT jam when snapping on empty chamber; either...

Folks, I am good gunsmith, but this has me stimmed: When gun is worked manually, it functions perfectly. However when FIRED, the slide jams rearward. (rear of slide is 2.0" behind the disassembly mark on left side.) The slide can not be pushed forward by hand. Tapping with mallet can move...

Looking for a source for Chinese SKS parts--any suggestions Thanks,:)

What happened to Steve's Gun Manual site ?? Checked this week and it says "can't download......" Anyone know ?? OR: know of good source for systematics ?

Have followed all the "Rules" but the slide will not come off frame after slide stop is pulled out. (As if the Ejector was not pushed down as required). Any one else have this problem with disassembly ???:banghead: Thanks, Jack

I have just had a "continued" failure of the P938 (9mm) using "Pierce FMJ" rounds. It does Not happen with any other ammo. The primer will "blow off" a piece, into the firing pin hole in the bolt/slide. A small piece of the primer will be in the firing pin hole (obviously round). Of course, a...

I need to replace the stock on a DAIWA AUTO 500, the "copy" of the Browning A5. Has anyone had this experience or know if the standard Browning butt stock will fit (with or w/o some inletting-fitting). ??? thanks, Oneeyejd: :uhoh:

I have heard 'Pros" & "Cons" on new Solo. Anyone have hands-on experince reg: Reliability/ workmanship /handling ??? THX :confused:

Can someone offer suggestions on number of reloads are "recommended" for .300 Win Mag (new Rem cases) ? OR what are the "signs" to review in checking the brass ? Obvious cracks, dents, out of round would be pitched out. I tried to track the number with permanent ink, but tumbling takes it...

I am preparing for an African safari in May and want to get the best load for plains animals. Gun: Savage Classic 114 ; .300 Win Mag: Nikon 4.5-16-42 BDC reticle. I have used H4350 at 66 grains with Nosler partition 180 Grains. It shows around 2850 fps average. Also Hydrid 100V at 68.2...