Search results for query: *

I have a Danish M1 Garand and am trying to research my barrel. The barrel imprint on the right side is marked ASC (within a circle) 1958 and PK also within a circle. I assume the PK is a Danish proof mark, but I cannot find any reference to ASC. I will note a few parts are stamped PB, which...

I used to make low pressure loads for an old parker s/s. I found out in addition to a powder shortage that now 7625 and PB(my favorite powders) are being discontinued at the end of 2014. Any suggestions? 1 1/8 oz. loads any powder, primer, stay with popular wads and hulls?

Anyone know minimum and maximum loads for a T/C pistol in .45 cal? Picked it up at a gun show with no operator manual. I will eventually call T/C but u could at least point me in the right direction. I know the gun can shoot both miniball and patch ball.

I know its possible to load IMR-4831 for .303 British, and I have a lot of H-4831 which I would like to use up and this caliber would be another use. I saw a reference to loading it about a year ago in a magazine, but can't find the recipe. The article did say max velocity was around...

My brother is changing powder and bullet for White Tail. He would like to know what others are shooting for both accuracy, distance and killing power. He has been using 4831 and 4350 with a 160 gr Nosler Partition. Now he is thinking of dropping down to a 130 or 140 Hornady SP interlock with...

I'm thinking of posting a Bushmaster Varmenter 5.56/.223 for sale, but can't seem to find a reasonable value for the gun. Availability in Wiisconsin is in constant flux and every new shipment has a new price. Many gun shops are listing guns on the internet, but when contacted they don't have...

I'm looking for a 9mm recipe that would use small rifle primers. I have an excess supply and would like to use them up. Shooting 9mm is mainly for target competition and practice. Bullets would be for whatever would work with the recipe. Right now, I cast 124 gr semi wadcutters and use...

I'm thinking of getting a .22 conversion for my Bushmaster Varmint .223...How well do the conversions shoot without buying a .22 upper. Is 50 yd squirrel hunting out of the question using a .224 barrel?

A friend is loading .45 ACP for the first time, though he loads a lot of rifle calibers, and he has noticed a slight bulge right at the case mouth of a couple of thousanths of a inch. Is this normal or what? He's loading 230gr FMJ.

I'm looking for information on loading black powder, pyrodex or 777 shot shells. Anyone have recipes or recommendations? I have a Parker side by side that has been approved for shooting by a gunsmith "as long as I keep the pressure down."

I'm looking for a low pressure load for 12 gauge 2 3/4" hunting grouse. I have an old Parker double with damascus barrels. A gunsmith said it is safe to shoot if I keep the pressure down. I have PB and Top Gun empties on hand. I did find a PB load at the IMR data sight of 19 gr PB with an...

I saw a reference by Ken Waters for loading H4831 for .303 have never found the recipe. Anyone have information on it. I purchased 25 lbs of 4831 along with other reloading supplies at an estate sale back in the mid-1990s and have been using it ever since(and so has all the hunting relatives)...

What does anyone suggest for using IMR 4350 in reloading .308 for a M1A. I've heared two views of the arguemnt. One says its too slow and will damage the operating rod, the other says it's ok as long as one stays under the prescribed M1 or M1A velocities recommended for the bullet. How...