Search results for query: *

I tried this in the handloading forum, but wanted to try here also Odd thing happened yesterday, took the Ruger Super Blackhawk Bisley Hunter 7.5in barrel, 44mag & Ruger GP100 357 6in barrel to the range to sight-in today. I was sighting in my GP100 today with new Williams Sights, it all went...

Odd thing happened today, took the Ruger Super Blackhawk Bisley Hunter 7.5in barrel, 44mag & Ruger GP100 357 6in barrel to the range to sight-in today. I was sighting in my GP100 today with new Williams Sights, it all went well with the 357. Then i moved onto the 44mag SBHH to check some loads...

What causes these burn / powder marks on the cases sides? Is it the crimp? to heavy? These where loaded with 5.1gr Tightgroup with 200gr Rainier RN plated bullets (1.26 COAL) and also some where 5.1 gr Tightgroup with 200gr Hornady HP XTP (1.23 COAL) , brass is Starline and wolf primers where...

I have a Lee Collet Die in 7mm-08 I neck sized 50 new Winchester Cases today to assure they all had the samre neck tension. With 3 cases left to do, I resized a case and as i was pulling the press arm back up to extract the shell past the internal sizeing ball the case became difficult to...

I have some brass (Lapua) when I first got it it was great, fired it once then neck sized it with and RCBS neck die. Afterwards the neck seems to out of align. Didnt notice till chambering some rounds. There have even been some loads where, when chambering the shell chambers hard and also...

Wanted to get some feed back on this. I have been reloading for about one year, things seem to be going well. Im always reading that one of the signs of High Pressure are a sticky bolt. I've only had one occassion were I was pretty sure the bolt being sticky was a sign of the high pressure...

:banghead:I have just started trying the neck sizing of some 308 Lapua Brass. The Die is an RCBS, I have cleaned it and inspected it with a light as best i can. Looking into the die it seems smooth and clean, but after resizing a case the neck has lines running along the neck length wise all...

Has anyone ever run across 308 Lapua Brass being difficult to slip into the shell holder when it is brand new, never fired? I bought a box of 100 from Cabelas and was resizing them to make every thing uniform, a few needed triming, but when putting them into the shell holder for resizing, some...

I have worked up a couple of loads for Savage 10FP 308, 20in Barrel Sierra 168MK Feberal Brass Federal 210 Primer 45gr BLC-2 Powder Nosler 165 BT Feberal Brass Federal 210 Primer 44.5gr BLC-2 Powder What should I expect to have to change as far as powder charge if any by changing to...

My father has the Rem 710 30-06 with the grey synthetic stock, he is what we call a frugal consumer, hence the 710. He wants to have a camo stock. Does anyone know of replacement stocks for this rifle? I have done some looking and cant find much.:banghead:

Hello all, I have been lurking around gathering information about reloading and decided to give it a try, many of you provided great information that helped in making my decision. I had decided on the RCBS Master Reloading Starter Kit,but then spoke to my uncle, a long time reloader, he had...