Just bought my first neck sizing die. This is safe if the brass has already been fired in it's designated rifle, right? Also, should I be "partial neck sizing" by turning the die back a turn off the shell holder? Pros and cons?
What is your case prep routine for once fired brass bought as factory cartridges? Do you trim it if it's already under max length? Do you bevel the case mouth if you skipped trimming?
I'm loading rifle cartridges for the first time for my .30-06.Someone told me that to figure out how deep to seat the bullet you should make a dummy cartridge and leave it long. Then close it in the action of your rifle and let the lands push the bullet in. Measure that and subtract .003 or .004...
I know it's not "firearm" related but it's definitely gun and fun related. I live in the suburbs and am about 45 min. away from the nearest outdoor range so I broke down and bought an airsoft 1911. What a blast! El Presidentes in my own back yard! Solo cups dropping like bowling pins. Not as...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.