Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

1500 xtr????

Discussion in 'Gunsmithing and Repairs' started by tiko_joe, Nov 13, 2007.

Thread Status:
Not open for further replies.
  1. tiko_joe

    tiko_joe Member

    Joined:
    Nov 13, 2007
    Messages:
    69
    Location:
    utah
    I have a Winchester 1500 xtr and have no idea how to breakdown. I bought it in great condition used w/out a manual. I,ve been searching on the internet w/out luck. I did find another thread on another site were some one had mentioned the 1400 being very similar but can not find anything on that one either. Does any one have any suggestions or know how to break one down them selves?
     
  2. robsc

    robsc Member

    Joined:
    Mar 26, 2007
    Messages:
    222
    Location:
    South Carolina
    I also have a Winchester 1500XTR 12ga. Unscrew the end cap and carefully slide forearm and barrel assembly forward together until clear of the magazine tube. Hold assembly tightly together while removing and until you get used to the procedure. The magazine tube slides into the bottom hollow of the forearm beneath the barrel channel. Remove receiver pin to drop the trigger assembly. To reassemble: Cock the bolt. Place the forearm back onto the barrel. Slide this assembly carefully together over the magazine tube. You will see again that the magazine tube slides inside the bottom hollowed portion of the forearm under the barrel channel. When completely seated replace end cap.
     
    Last edited: Nov 17, 2007
  3. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
Thread Status:
Not open for further replies.

Share This Page