I actually ended up a little shorter than you. I made some dummys at 1.175 and when I cycled them to check for setback, the ears of the feed ramp made some pretty good gouges in the bullet to a point that I'm pretty sure accuracy would be affected. I dialed my bullet seat down in increments of .01 +/- .005 until I reached the point that no bullets were marred and that was 1.150. This will be my test length. It will probably take me two weeks to get to the range, but I'll get there and report back.
I have read about this feed ramp issue many times and I probably should take all my guns in to have some tuning done, but I haven't.
I have read about this feed ramp issue many times and I probably should take all my guns in to have some tuning done, but I haven't.