ez45
Member
My problem is my reloads will chamber okay in one gun but not another. I have a ruger 50th anniversary flattop and an original flattop in 357 magnum. One round will fit in the 50th cylinder but not the original.
It will go maybe 2/3rds in and then stop. I have checked the cylinder and there is no lead buildup or ring from shooting 38 special. The crimp on the bullet is not excessive or causing any kind of bulge. I suspect it's just one has a smaller chamber than the other.
But, even so, shouldn't the rounds fit after full length resizing? Should I try another brand of dies? Do I have to separate the brass for each gun? Any ideas?
It will go maybe 2/3rds in and then stop. I have checked the cylinder and there is no lead buildup or ring from shooting 38 special. The crimp on the bullet is not excessive or causing any kind of bulge. I suspect it's just one has a smaller chamber than the other.
But, even so, shouldn't the rounds fit after full length resizing? Should I try another brand of dies? Do I have to separate the brass for each gun? Any ideas?