Swamprabbit
Member
Not trying to hijack the thread - just hoping to expand on it.
I'm a little surprised that no-one mentioned IMR-4227. I have seen the manuals recommend this as an accurate load but I never had any real success with it. By not seeing any other posts about it, was that everyone else's findings?
I have been using 2400 in .357 and .44mag for several years. I like its performance but I do have problems with unburned powder clogging up the extractors on my S&Ws. I use standard Winchester Small Pistol primers and am considering trying something like CCI 550 magnum pistol primers to see if that helps. Do any of the other powders mentioned here (like H-110) burn better than 2400?
I'm a little surprised that no-one mentioned IMR-4227. I have seen the manuals recommend this as an accurate load but I never had any real success with it. By not seeing any other posts about it, was that everyone else's findings?
I have been using 2400 in .357 and .44mag for several years. I like its performance but I do have problems with unburned powder clogging up the extractors on my S&Ws. I use standard Winchester Small Pistol primers and am considering trying something like CCI 550 magnum pistol primers to see if that helps. Do any of the other powders mentioned here (like H-110) burn better than 2400?