MissouriCrowinMass
Member
I found these casings at the range last week. Two were cracked and all had the primers really catered out. They weren't flat at all, just all mushroomed. I've reloaded for two years. 9mm, 45 ACP, .40 S&W, 7.5x55 and just started .30 carbine. I'm pretty conservative. Never had any funny looking primers. I had a couple of questions?
I never saw the Lee Factory Crimp looks like. I use RCBS Dies with the taper crimp. Are these Lee Factory?
I'm having a hard time with .30 Carbine Reloading. (Love to shoot the Carbine!) I have a set of the older RCBS Dies where the Sizer Die is just that and the Decapper Die bells the casemouth. No matter how hard I try to barely adjust the combo decapper pin & belling unit......I'm getting bad bullet setback. These are Carbide Dies. I use One Shot Lube?
Any advice is appreciated. I don't post much but I've learned alot of this Board. Thanks
I never saw the Lee Factory Crimp looks like. I use RCBS Dies with the taper crimp. Are these Lee Factory?
I'm having a hard time with .30 Carbine Reloading. (Love to shoot the Carbine!) I have a set of the older RCBS Dies where the Sizer Die is just that and the Decapper Die bells the casemouth. No matter how hard I try to barely adjust the combo decapper pin & belling unit......I'm getting bad bullet setback. These are Carbide Dies. I use One Shot Lube?
Any advice is appreciated. I don't post much but I've learned alot of this Board. Thanks