1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

5.45x39 Accuracy

Discussion in 'Rifle Country' started by SharpsDressedMan, Apr 4, 2010.

Thread Status:
Not open for further replies.
  1. SharpsDressedMan

    SharpsDressedMan member

    Feb 18, 2007
    NE Ohio
    Spent a day at the range last week, and decided that the results merited discussion. I have a rifle built from an unfired condition AK74 kit (it's either Romanian or Bulgarian, I can't remember), and it has a Texas Weapon Systems rail and Zeiss Z-point sight. Now a red dot at long range isn't the best for acute accuracy testing, but it was all I had at the time. Targets are the B29 half size silhouette.[​IMG][/URL][/IMG] [​IMG][/URL][/IMG] [​IMG][/URL][/IMG] There was a 7-10mph crosswind, so some of the lateral spread is due to the wind. At 200 yards, the "ball" of the red dot covered the width of the target, but I tried to index centered top to bottom. I can't really "see" the center of the target, but as long as one is consistent in holding, groups way smaller than the 8-10inch width of the red dot can be achieved. The ammo was regular Russian military surplus from the 1080 spam cans. I can't wait to test it with a suitable, conventional target scope. The 5.45 would seem to be evey bit as accurate as the .223 from a similar platform gun.
    Last edited: Apr 4, 2010
Thread Status:
Not open for further replies.

Share This Page