O_Blade_O
Member
Hi there,
I just got all my reloading equipment and making first batches of MY Ammo, what a satisfaction, after monthsworth of wait for a damn set of dies.
By the way, i'm on the other side of the pond and have all RCBS branded equipment, i like this stuff.
Here's my very first, all by me made ammo:
You can notice that is 9x21mm, not 9mm Luger, but it makes no differences for loads.
Now, these are made with a 124 grain RN FMJ Copper plated (100um plating, 0,004 inches), 4,7 grains of VithaVuori N340 as their loading manual (as for 9x21mm) says about as the starting load... and it is rated for 1140 fps.
I'd like to make a subsonic round with these components, as a beginner, i purchased a bulk of these.
I read on their manual that with a 4,5 grain of N340 powder should stay at 1186 fps...
How could i tweak it? 4,4 grains should go under the 1180 FPS barrier?
Thanks and sorry for all the questions! Thanks again.
I just got all my reloading equipment and making first batches of MY Ammo, what a satisfaction, after monthsworth of wait for a damn set of dies.
By the way, i'm on the other side of the pond and have all RCBS branded equipment, i like this stuff.
Here's my very first, all by me made ammo:
You can notice that is 9x21mm, not 9mm Luger, but it makes no differences for loads.
Now, these are made with a 124 grain RN FMJ Copper plated (100um plating, 0,004 inches), 4,7 grains of VithaVuori N340 as their loading manual (as for 9x21mm) says about as the starting load... and it is rated for 1140 fps.
I'd like to make a subsonic round with these components, as a beginner, i purchased a bulk of these.
I read on their manual that with a 4,5 grain of N340 powder should stay at 1186 fps...
How could i tweak it? 4,4 grains should go under the 1180 FPS barrier?
Thanks and sorry for all the questions! Thanks again.
Last edited: